HS2000

The HS 2000 has no traditionally and externally located manual safety lever. Therefore make sure that the trigger is only touched if you intend to fire.

1. GRIP SAFETY, It is located on the upper rear portion of the pistol’s grip. Properly gripping the HS 2000 in your shooting hand will automatically press the grip safety. Once the grip safety is depressed, the sear can disengage from the firing pin if the trigger and trigger safety are pulled Note: While the grip safety is engaged, the entire action of the pistol is locked.

2. TRIGGER SAFETY, It is incorporated into the trigger in the form of a lever, and in the untouched state locks the trigger from moving backward. The trigger can only be pulled if depressed together with the trigger safety. The safety locked action pistol is, therefore, ready for firing at any time once the grip safety is disengaged and the trigger with trigger safety is pulled.

3. FIRING PIN BLOCK/DROP SAFETY , A spring loaded pin projects into the firing pin cut-out, and blocks the movement of the firing pin. This safety is only released when the grip safety is disengaged, the trigger safety is disengaged, and the trigger is pulled back.

4. OUT OF BATTERY SAFETY, A cut out in the slide will only allow the trigger bar to disengage the sear from the firing pin only if the side is fully forward and in battery.

THE SAFETY DEVICES 1, 2, and 3 above are designed to
prevent the weapon from unintentional discharge.

SAFETY DEVICE 4 is designed to protect the shooter
from firing the pistol in an unsafe condition.

	HS2000 was imported by Intrac Knoxville, TN between 2000 and 2002.
	This HS2000 pistol was imported by Intrac Knoxville, TN
	HS2000 weighs 32.03 ounces with a full 15 rnd magazine, the overall length is 7.2 inches.
	HS2000 Hrvatski Samokres (Croatian Pistol)

HS2000 Review